11
10. Changing the Setting
The time and the watering time can be changed using the control knob
(Run Time).
The changes are accepted after approx. 5 seconds and this is signalled
acoustically by a double beep. If the water timer is not reset the original
starting time remains unchanged.
Making changes during watering
You can change the watering time (Run Time) during an automatic water-
ing program as follows:
.If the elapsed watering time is shorter than the new watering time you
have selected, then the new watering time is valid.
Example:
Old Run Time = 10 minutes, changed after 5 minutes to 30 minutes.
The total watering time is then 30 minutes.
.If the watering time which has already expired is longer than the new
watering time, the water flow is interrupted in the next minute.
If you have already chosen the starting time (Start Time / Run Time
already set) any changes you make to the watering frequency (Frequency)
are active as soon as the next watering program starts.
If you have forgotten the current start time, you should reset the Water
Timer and then re-enter the watering data.
11. Battery
11.1 Status indicator
If the battery capacity falls below a certain level, a warning signal sounds
every 15 seconds. The programs you have set are not run. The water flow
cannot be opened manually. If a valve is open, however, it will be closed.
11.2 Changing the battery
If the battery capacity is too low (the warning signal beeps every
15 seconds), you must change the battery. To do this, the water timer
must be removed from the tap.
Important: Changing the battery deletes the data you have set.
To Next Page
Loading...
Need help?
General
