19
AFTER SALES SUPPORT
1300 922 271
service.australia@
isc-gmbh.info
GLCS 85 E
09/201491568
6.5 Lock the chain (Fig. 7)
Tighten the chain locking screw (6)
6.6 Grinding the chain links (Fig. 10/11)
Important!
• Only use the equipment for sharpening saw chains.
Never grind or cut other materials.
• Before sharpening the saw chain clamp it into the
chain bar. This will prevent jamming of the grin-
ding wheel caused by a loose saw chain.
• Slowly guide the grinding wheel to the saw blade.
If the grinding wheel approaches the saw chain
too quickly or jerkily, this may cause damage to
the grinding wheel. Injuries may result from cata-
pulting parts!
• Switch the appliance on at the ON/OFF switch (9)
• Carefully bring the grinding wheel (8) with grin-
ding head (10) so that it is against the set link
• Switch the appliance off at the ON/OFF switch (9)
• Every second link in the chain must be sharpened
in this way. To know when every second link in
the entire chain has been sharpened, mark the
first link (e.g. with chalk). Once all cutting links on
one side have been sharpened, the grinding angle
must be set to the same number of degrees on the
other side. You can then begin to sharpen the links
of the other side (without having to make any
further adjustments).
GLCS_85_E_AUS_SPK7.indb 19 05.06.14 13:56
To Next Page
Loading...