Description of symbols
The rating plate on your tool may show symbols. These represent important
information about the product or instructions on its use.
Conforms to relevant safety standards.
Wear hearing protection. Wear eye protection. Wear head protection.
Read these instructions for use carefully.
Wear safety footwear.
Wear safety gloves.
Warning.
Use at a distance of at least 10m from other people.
Explosive material.
Extremely hot surface. Do not touch a hot muffler, gear box or cylinder, you
may get burned. These parts get extremely hot from operation and remain
hot for a short time after the unit is turned off.
WARNING! Danger of kickback.
Do not operate unit in the rain.
Do not attempt to hold saw with one hand.
Do not use the point of the bar.
Hold saw properly with both hands.
General Information & Safety Instructions
2
Symbols on the machine
Fuel inlet.
(Position: under the fuel tank cap.)
Chain oil inlet.
(Position: next to the oil tank cap.)
On/Off.
(Position: on the on/off switch.)
Setting the on/off switch to Off,
stops the engine immediately.
Run position.
Start position (when engine is cold.)
Choke control
(Position: next to knob on the filter cover)
High run adjustment screw.
Low run adjustment screw.
Idle adjustment screw.
(Position: left side of machine close
to pull start handle.)
Chain brake released (hollow arrow)
and activated (solid arrow.) (Position:
right side of machine, on chain drive cover.)
To Next Page