6
You will notice the following symbols on the chain saw and in the Owner’s and Safety Manual:
The port to refuel the Petrol & Oil mixture
Position: fuel tank cap
The port to refuel the “CHAIN OIL”
Position: oil cap
On/Stop switch indication. Moving the engine switch to the “O” (STOP) position, the engine
stops.
Position: rear-left of the unit
Choke position indication. Pulling the choke knob out will close the choke.
Position: rear-right of the unit
Chain oil adjuster nut idication.
“ MIN” direction-the oil flow will decrease.
“ MAX” direction-the oil flow will increase.
Position: bottom of the clutch side
The position of H-needle
The position of L-needle
The position of T-idle adjusting screw
Position: rear-left of the unit
Stop engine
RCM marking
Chain oil fill/oil pump
Engine-manual start
Heated handle-temperature control
Choke-open
Choke-closed
To Next Page
Loading...