SETTING WAKE-UP TIME AND SNOOZE FUNCTION
Push the ALARM button once to display wake-up time of alarm 1 and alarm 2
1) Press the ALARM button and hold for 2 seconds. The wake-up times of alarm 1
and 2 will be displayed and the alarm 1 wake-up hour will flash. Use the +, or – buttons to set
the required wake-up hour and confirm with the ALARM button.
2) The wake-up minute will flash. Use the +, or – buttons to set the required wake-up minute and
confirm with the ALARM button.
3) The wake-up hour of the alarm 2 will flash. Use the +, or – buttons to set the required wake-up
hour and confirm with the ALARM button.
4) The wake-up minute will flash. Use the +, or – buttons to set the required wake-up minute.
Confirm the setting and finish the setting by pushing the ALARM button.
Note: If no button is pressed for 20 seconds, the setting mode will be terminated.
Activating and deactivating the alarm clock
To activate or deactivate alarm 1 slide the switch ON/OFF on the side to the ON position (activated) or
OFF (deactivated). Alarm 1 is activated if the icon is displayed.
To activate or deactivate alarm 2 slide the switch ON/OFF on the rear to the ON position (activated) or
OFF (deactivated). Alarm 2 is activated if the icon is displayed.
Snooze function
To deactivate the snooze function, push any button except .
To activate the SNOOZE function, push the button while the alarm is active, icons , or
will flash and the alarm will be postponed for 5 minutes, and then reactivated. This process may be
repeated.
If no button is pressed, the alarm with deactivate automatically after 2 minutes. The wake-up alarm will be
repeated after 24 hours at the set time.
PROJECTION
The weather station has a projection of time and indoor temperature. The ideal distance of the projection
surface is 1.5 to 3 meters in an unlit room.
The projector tube can be tilted by 90° back and 90° forward.
When the main unit is powered by batteries only, the projection and the backlight will be on for 8 seconds
using the touch button on the top of the main unit. When powered with the AC adaptor the
projection will be permanent. The projection can be activated (ON) or deactivated (OUT) using the
Projection switch on the rear of the main unit.
To rotate the projected image by 180°, push the button
Projection is off while receiving the DCF-77 signal for time and date adjustment.
To Next Page
Loading...
