27
Unit Operation
Setup Menu/Memory
Memory
The ‘Memory’ tab contains the settings for unit memory, allows you to
reset the unit to the factory setup and allows you to review software version
information. To access the ‘Memory’ tab, use the arrow keys to highlight it.
Remember
The Fishfinder 100 can be set to remember All of the unit settings
including the Adjustment Bar or the items in Setup Only.
To Select a Memory Setting:
1. Highlight the ‘Memory’ tab on the Setup Menu.
2. Highlight the ‘Remember’ field and press ENTER.
3. Choose ‘All’ or ‘Setup Only’, press ENTER to accept the selection.
Factory Setup
To Restore the Factory Settings:
1. Highlight the ‘Memory’ tab on the Setup Menu.
2. Highlight the ‘Factory’ Setup button and press ENTER.
3. Choose ‘OK’ to reset the unit or ‘Cancel’ to abort.
Software Version
The ‘Software Version’ Button will report information about the current
software version that is in the unit.
To Activate the Software Version Window:
1. Highlight the ‘Memory’ tab on the Setup Menu.
2. Highlight the ‘Software Version’ button and press ENTER.
3. Press ENTER to close the information window.
Remember Selections
Software Version Information
Reset to Factory Settings
100 Operation.p65 2/16/00, 10:07 AM27
To Next Page
Loading...
Need help?
General
