Garmin Force - Garmin Support Center

3
Turn on the remote control.
4
On the remote control, select > Settings
> Remote > Pair
> Start
.
on the trolling motor display panel changes to green when
the connection is successful.
Pairing the Foot Pedal
The foot pedal is paired with the trolling motor at the factory, but
you may need to pair them again if the connection is broken.
1
Turn on the trolling motor.
2
On the trolling motor display panel, press three times to
enter pairing mode.
on the trolling motor display panel illuminates blue as it
searches for a connection.
3
Connect the foot pedal to power using the power cable, or
insert batteries to turn it on.
4
Within 30 seconds of turning on the foot pedal, hold until
the status LED on the foot pedal illuminates blue.
5
Release .
The status LED on the foot pedal illuminates blue as it
searches for a connection, then turns off when it pairs
successfully with the trolling motor.
on the trolling motor display panel changes to green when
the connection is successful.
More Information
Downloading the Manuals from the Web
You can get the latest owner's manual and translations of
manuals from the Garmin website.
1
Go to www.garmin.com
/manuals/force_trolling_motor
.
2
Download the manual.
Garmin
Support Center
Go to
support.garmin.com for help and information, such as
product manuals, frequently asked questions, videos, software
updates, and customer support.
Maintenance Needs and Schedule
To maintain your warranty, you must perform a series of routine
maintenance tasks as you prepare your motor for the season. If
you use or transport the motor in dry, dusty environments
(traveling on gravel roads, for example) you should perform
these tasks more often during the season.
For detailed procedures and information on service and
replacement parts, download the
Force Trolling Motor
Maintenance Manual from www.garmin.com/manuals/force
_trolling_motor.
• Examine the power cable for wear, and patch or repair as
necessary .
• Check the power terminals, and clean them if necessary .
• Lubricate the hinges and bushings .
• Clean and lubricate the stow and deploy latch mechanism .
• Check the mount rails, and replace them if necessary .
• Check the mount bumper, and replace it if necessary .
• Clean or replace the anodes in the propeller drive motor .
6 Quick Start Manual
DRAFT