Garmin Force Installation Instructions

FORCE
®
KRAKEN TROLLING MOTOR
INSTALLATION INSTRUCTIONS
Getting Started
WARNING
See the Important Safety and Product Information guide in the product box for product warnings and other
important information.
Failure to install this device according to these instructions could result in personal injury, damage to the vessel
or device, or poor product performance.
Failure to follow these warnings, cautions, and notices could result in personal injury, damage to the vessel or
device, or poor product performance.
Do not run the motor when the propeller is out of the water. Contact with the rotating propeller may result in
severe injury.
Do not use the motor in areas where you or other people in the water may come into contact with the rotating
propeller.
Always disconnect the motor from the battery before cleaning or servicing the propeller to avoid injury.
CAUTION
For the best possible performance and to avoid potential injury, damage to the device, or damage to your vessel,
installation by a qualified marine installer is recommended.
To avoid possible personal injury, always wear safety goggles, ear protection, and a dust mask when drilling,
cutting, or sanding.
When stowing or deploying the motor, be aware of the risk of entrapment or pinching from moving parts, which
can result in injury.
When stowing or deploying the motor, be aware of slick surfaces around the motor. Slipping when stowing or
deploying the motor may result in injury.
NOTICE
When drilling or cutting, always check what is on the opposite side of the surface to avoid damaging the vessel.
Tools and Supplies Needed
• Drill and a
5
/
16
in. (8mm) drill bit
• #2 Phillips screwdriver
• 4mm hex bit or wrench
•
9
/
16
in. (14mm) socket
• Torque wrench
• Circuit breaker rated for continuous 60A
• Trolling motor plug and receptacle rated for 60A or greater (optional)
• 6, 4, or 2AWG (16, 25, or 35mm
2
) wire for extended runs of the power cable
• Solder and heat-shrink tubing, if extending the power cable
• Stainless steel pan head
1
/
4
-20 (M6x1) bolts (if the included bolts are not long enough to mount the motor to
the deck)
TA-2019/5242
TA-2019/5243
TA-2019/5244
GUID-09FCEEF1-A8CD-4B9C-8A62-161A75852017 v1June 2023

Garmin Force Specifications

General

Type	Electric Trolling Motor
GPS	Yes
Blade Material	Composite
Thrust	80 lbs
Integrated Sonar	Yes
Wireless Remote	Yes
Steering	Electric
Battery Compatibility	Lithium
Control Interface	Wireless Remote