5 Hold the adapter and cord to your wrist, examine the fit, and determine where to tie the second knot.
6 Repeat steps 3 and 4 on the second adapter.
7 Repeat steps 2 through 6 for the second bungee cord.
8 Cut off the excess cord, and leave at least 6 mm (0.25 in.) at the end of each knot.
9 Press the QuickFit adapters onto the watch.
Limited Warranty
The Garmin standard limited warranty applies to this accessory. For more information, go to www.garmin.com
/support/warranty.
Installation Instructions 3
To Next Page
Loading...
