%DLO0RXQWLQJ
,QVWUXFWLRQV
:$51,1*
See the Important Safety and Product
Information guide in the GPS device
product box for product warnings and
other important information.
Garmin
®
strongly recommends having an
experienced installer with the proper
knowledge of electrical systems install the
device. Incorrectly wiring the power cable
can result in damage to the vehicle or the
battery and can cause bodily injury.
&$87,21
Always wear safety goggles, ear
protection, and a dust mask when drilling,
cutting, or sanding.
NOTICE
The metal contacts on the GPS device
and the mount should be kept dry to avoid
equipment damage. Use the weather cap
on the mount at all times when the unit is
not mounted to keep the metal contacts
dry and protected.
To obtain the best performance and to
avoid damage to your boat, install the
device according to these instructions.
Read all installation instructions before
proceeding with the installation. If you
experience difficulty during the installation,
contact Garmin Product Support.
7RROV1HHGHG
• Drill
• Phillips screwdriver
• 9.5 mm (
3
/
8
in.) wrench or socket
• 3 bolts or 3 screws:
◦ #8 (4 mm) pan-head machine bolts
with nuts and washers, and a
5 mm (
5
/
32
in.) drill bit
◦ #8 (4 mm) pan-head self-tapping
screws and a 1.5 mm (
1
/
16
in.) drill
bit
0RXQWLQJ&RQVLGHUDWLRQV
NOTICE
The swivel base must be mounted using
pan-head machine bolts or self-tapping
screws. Using screws with countersunk
heads can damage the mounting bracket.
ms install thems install the
he power cablehe power cable
the vehicle or thethe vehicle or the
se bodily injury.dily injury.
a dust mask whea dust mask wh