Garmin TT 10 - User Manual

TT™ 10 Battery Replacement
Instructions
TT 10 Components
À
Back plate
Á
Power key
Â
Battery cover
Ã
Connectors
Ä
Battery
Removing the Old Battery
Before you replace the battery, you must remove all dirt, water,
and debris from the device. Also, you need a small Phillips
screwdriver.
1
Remove the six screws from the outer edges of the back
plate.
TIP: You should leave the two inner screws in place.
2
Pry off the back plate.
3
Disconnect the four-pin and five-pin connectors.
4
Remove the three screws that secure the battery cover.
5
Remove the battery cover and the battery.
Remember the orientation of the battery. You must install the
new battery the same way.
After you remove the old battery, contact your local waste
disposal department to properly recycle the battery.
Installing the New Battery
Before you replace the battery, you must remove the old battery
(page 1). You also need a small Phillips screwdriver. You may
need a small flat screwdriver to connect the connectors.
1
Install the new battery with the connector on the end nearest
the Power key.
2
Replace the battery cover.
3
Replace the three screws to secure the battery cover.
4
Connect the five-pin and four-pin connectors.
You may need to use a flat screwdriver to help secure the
connectors.
5
Select the Power key to test the connections.
When properly connected, a tone is emitted and the status
LED blinks green.
TIP: You can turn off the device before proceeding.
6
Make sure the gasket located inside the bottom cover is fully
seated.
7
Replace the back plate.
8
Replace the six screws to secure the back plate.
After you install the new battery, charge the collar completely.
Limited Warranty
The Garmin
®
standard limited warranty applies to this
accessory. For more information, go to www.garmin.com
/support/warranty.html.
July 2012
190-01500-02_0A Printed in Taiwan

Summary

TT 10 Battery Replacement Instructions

TT 10 Components

Identifies and labels the key components of the TT 10 device, including the back plate, power key, and battery.

Removing the Old Battery

Step-by-step instructions for safely removing the old battery from the TT 10 collar, including screw removal and connector disconnection.

Installing the New Battery

Detailed guide for installing the new battery, replacing the cover, reconnecting connectors, and testing the installation.

Limited Warranty

Garmin TT 10 Specifications

General

Range	Up to 9 miles
High-sensitivity GPS/GLONASS receiver	Yes
Stimulation/Vibration/Tone	Yes
LED beacon light	Yes
Sleep mode	Yes
Replaceable collar strap	Yes
Type	Dog Tracker
Battery type	Rechargeable lithium-ion
Water Rating	IPX7
Collar size	Fits collars up to 1 inch wide
Compatibility	Astro® 430