Performing a Static Torque Test
The static torque test is intended for advanced cyclists and
installation experts. This test is not required under normal
circumstances to achieve good results with the Vector 3 system.
This test is available for the Edge 1000, 810, and 510 devices.
Garmin recommends performing the static torque test a
minimum of three times and averaging the reported torque
values.
Go to www.garmin.com/Vector3owner, and click on the
FAQs link for detailed instructions.
Following repeated static torque tests, if the reported torque
value is consistently different than the expected value, you can
enter a scale factor for one or both pedals. The scale factor is
stored in the pedal and adjusts the power value that is
calculated on the pedal. The scale factor is sent to the Edge
device and stored on Edge device.
Crank Compatibility
TBD .
Third-Party Devices
For a list of devices that are compatible with Vector 3, go to
www.garmin.com/Vector3owner.
Appendix 9
NOTICE
To Next Page
Loading...
Need help?
General
