EasyManuals Logo

Garmin VECTOR 3 A03220 User Manual

Garmin VECTOR 3 A03220
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
Introduction
Read all instructions carefully before installing and using the
Vector system. Improper use could result in serious injury.
See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
Move your bike chain to the largest chain ring and the
smallest cassette gear.
The bike chain should be in the outermost position to
determine proper clearance between the pedal pod cable and
the chain.
NOTE:
There must be at least 5 mm clearance
À
between
the chain and the crank arm.
Go to www.garmin.com/Vector3owner for the latest information
including bike compatibility, software updates, and video
tutorials.
Thank You
Thank you for your Vector 3 or Vector 3S purchase. This
manual covers both Vector 3 systems.
Vector 3 was designed for cyclists, by cyclists, to provide an
outstanding experience of owning a precision power
measurement system for your bike.
Vector 3 is simple, accurate, and easy to use.
For software updates, video tutorials, and everything you need
to get years of service out of your Vector 3, go to
www.garmin.com/Vector3owner.
Now it's time to put the power under your feet and get out there
and ride.
Getting Started
1
Install the Vector 3 components (Installing the
Vector 3
Components, page 1).
2
Install the shoe cleats (Installing the Shoe Cleats, page 2).
3
Pair Vector 3 with your Edge
®
device (Paring Vector 3 with
Your
Edge 1000, page 2).
4
Go for a ride (Your First Ride, page 2).
5
View your history (Vector 3 Data, page 3).
6
Send your history to your computer (Sending Your Ride to
Garmin Connect, page 3).
Installing the Vector 3 Components
The installation steps for the Vector 3 and Vector 3S systems
are very similar. Procedures that are specific to the Vector 3S
system are noted.
Preparing for the Installation
1
Confirm the compatibility of your bike at www.garmin.com
/Vector3owner.
2
Find the sensor ID that is engraved on the spindle, and
write
it down.
3
Remove the existing pedals.
4
Clean the threads, and remove old grease.
Introduction 1
NOTICE
WARNING

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Garmin VECTOR 3 A03220 and is the answer not in the manual?

Garmin VECTOR 3 A03220 Specifications

General IconGeneral
BrandGarmin
ModelVECTOR 3 A03220
CategoryBicycle Accessories
LanguageEnglish

Related product manuals