To Next PageTo Next Page
Need help?Do you have a question about the Garnet SEELEVEL II 714 and is the answer not in the manual?
General| Brand | Garnet |
|---|---|
| Model | SEELEVEL II 714 |
| Category | Measuring Instruments |
| Language | English |
Describes the sender panel, its function, cutting, and auto-calibration capabilities.
Details the display unit, its function, and automatic updates every 10 seconds.
Explains how to read tank levels, including hold mode functionality on the primary display.
Describes how to read outside temperature and toggle between two sensors if installed.
Explains how to toggle the fifth display between battery voltage and LPG tank level.
Guides on displaying code revision, primary/secondary status, and setting display options.
Details calibrating temperature readouts to degrees Fahrenheit or Celsius using the display buttons.
Explains calibration for primary or secondary display setup, typically done at installation.
Describes calibrating the number of senders per tank (one or two) for each tank individually.
Guides on programming the LED brightness level for optimal visibility in different lighting conditions.
Details the procedure for calibrating the LPG sender, requiring the tank to be full.
Explains how to program senders for Fresh, Grey, or Black tanks by cutting tabs on the sender.
Guides on programming senders for single, top, or bottom unit configuration using sender tabs.
Covers mounting the display unit and connecting wiring according to the provided table.
Details determining the best mounting location for senders on tanks, ensuring flat contact and avoiding metal.
Explains how to measure and cut sender length for tanks less than 13" and greater than 13" tall.
Describes peeling adhesive, positioning sender, connecting wires, and securing them.
Covers final calibration steps and initial testing, including signal power checks.
Details LPG sender calibration and connecting pump/heater switches, with a warning on amperage.
Lists and explains common display trouble codes like OPn, Sht, Err, StA, nbo, ntP for senders and LPG.
Provides methods to check wiring and individual senders for short circuits or open circuits.
Explains how to check sender signal power and sender height diagnostics for performance issues.
Offers tips for troubleshooting unresponsive panels and console disagreements in dual display setups.
Outlines the warranty terms, limitations, and procedures for returns and claims.
Provides contact details for Garnet Instruments Ltd. in Canada and Garnet Technologies Inc. in the United States.
