Garnet SeeLeveL Special 809-DM User Manual

Printed in Canada
www.garnetinstruments.com
MODEL 809-DM MANUAL
Truck Multi-Tank Dispensing System
IMPORTANT OPERATOR INFORMATION
DATE INSTALLED: _______________________________________________________________________________
UNIT NUMBER: _________________________________________________________________________________
COMPARTMENTS: ______________________________________________________________________________
DISPLAY CALIBRATION UNITS (e.g. pints, gallons): _____________________________________________
MINIMUM TANK READOUT: ___________________________________________________________________
MAXIMUM TANK READOUT: ___________________________________________________________________
BYPASS RESET ALARM POINT (A3): ____________________________________________________________
OVERFILL HORN WARNING POINT (A2): _______________________________________________________
OVERFILL SHUTDOWN POINT (A1): ____________________________________________________________
TM

Garnet SeeLeveL Special 809-DM Specifications

General

Brand	Garnet
Model	SeeLeveL Special 809-DM
Category	Measuring Instruments
Language	English

Summary

Gauge Description and Components

Display Operation and Navigation

Alarm Operation and Configuration

Dispense Alarm Operation

How to set and use the dispense alarm for accurate product dispensing operations.

Rising Level Alarm

Detects and alerts on improper tank filling causing an unexpected level rise.

Overfill Warning Alarm

Overfill Shutdown Alarm

An emergency shutdown function to prevent tank overfilling and potential spills.

Programming Overfill Alarm Points

Instructions for setting overfill warning and shutdown alarm trip points using the programmer.

Calibration Programming Instructions

Programming Gauge Display into Inches

Step-by-step guide for calibrating the gauge display using inch measurements.

Copying Gauge Display to Another Unit

Programming Gauge from Calibration Table

Method to input calibration data from a prepared table into the gauge.

Programming Gauge from Memory Table

Instructions for loading calibration data from stored memory locations.

Serial Interface Commands and Communication

Setting Dispensing Amount

Installation Guide for the 809-DM System

Troubleshooting Guide and Diagnostics

Testing the Sender Bar

Procedure to test sender bar functionality using the programmer and optical connection.

Testing the Display

Steps to verify the gauge display unit's operation and integrity.