The unit has memory. If power is lost,all of the
control settings(mode,fan speed,on/off and
configuration) are saved. So when power
is restored,the unit will start back up in the mode
(and configuration) it was in.
Automatically keeps
he evaporator from
freezing. The
ompressor is turned ff and the
indoor fan is turned on when the evaporator
temperature is too low. If the evaporator
temperature is not too low,
his function is off.
O O
If the room temperature falls to 4.5 C/8 F
below the set point temperature,the reverse
cycle heat is shut off and the electric strip heat
is turned on for one cycle until room temperature
The touch pad has buttons for MODE,FAN,
POWER,SETPOINT UP and SETPOINT DOWN.
It also has LEDs that correspond to the mode,
fan speed,power and setpoint operation,to
indicate the unit's
tatus.LEDs for HIGH,MED
and LOW indicate the fan speed that is selected.
LEDs for FAN,COOL and HEAT indicate which
operating mode is active.LED for POWER is the
N/OFF status LED.If the unit is in ON mode,
the LED will be green.If the unit is OFF,the LED
will be off.
(this is indicated on some products by a light on the plug head).
If power supply cord is damaged, it can not be repaired. It MUST be replaced by one from the manufacturer.
When 265V units are to be installed,the power supply must be permanent wiring.Permanent
wiring may be done through the accessory subbase. An exposed cord connection on 265V units
is not permitted.
air conditioner.
button. You
button. You
new one can be obtained from the manufacturer
features.
Warm-Up
equalize
returns to the set point.
To Next Page
Loading...
