Unit Parts
And Major
Functions
Page 8
Energy-Saving Tips
• DO NOT
set the unit to excessive temperature levels.
• While cooling, close the curtains to keep out direct sunlight.
• Doors and windows should be kept closed to keep cool or warm air in the room.
•
DO NOT
place objects near the air inlet and outlet of the unit. This will reduce the efficiency of the unit.
• Set a timer and use the built-in SLEEP/ECONOMY mode if applicable.
• If you don’t plan to use the unit for a long time, remove the batteries from the remote control.
• Clean the air filter every two weeks. A dirty filter can reduce cooling or heating efficiency.
• Adjust louvers properly and avoid direct airflow.
The air conditioner turns to FAN only mode
from COOL or HEAT (for cooling and
heating models only) mode.
When indoor temperature reaches the
temperature setting on air conditioner, the
compressor will stop automatically, and the air
conditioner will turn to FAN only mode. The
compressor will start again when the indoor
temperature rises on COOL mode or falls on
HEAT mode (for cooling and heating models
only) to the set point.
Dripping water may mccumulate on the surface of
the indoor unit when cooling in areas with relatively
Adjust the horizontal louver to the maximum air
outlet position and select HIGH fan speed.
Heating mode (for cooling and heating
models only)
The air conditioner draws in heat from the
outdoor unit and releases it via the indoor unit
during heating operation. When the outdoor
temperature falls, heat drawn in by the air
conditioner decreases accordingly. At the same
time, heat loading of the air conditioner increases
due to larger dierence between indoor and
outdoor temperature. If a comfortable
temperature can't be achieved by the air
conditioner, we suggest you use a supplementary
heating device.
Lightning or a car wireless telephone operating
nearby may cause the unit to malfunction.
Disconnect the unit from the power source and
ON/OFF button on the remote controller to
restart operation.
Closing the curtains while heating also
helps keep the heat in
Doors and windows should be kept
closed
high humidity (relative humidity higher than 80%).
then reconnect it. Push the
To Next Page
Loading...
Need help?
General
