Fitting Guidelines
The oven is manufactured to work with signal-phase alternating current(120/240V
supply system).
The connection diagram is also found on the cover of the connection holder.
Remember that the connection wire should match the connection type and the
power rating of the oven.
Before connecting the oven to the power supply it is important to read the infor-
mation on the data plate and the connection diagram.
Bellows Wiring Method
Step 1: Remove the wiring strip(on the top), as shown below:
Step 2: Connect the green wire, red wire and black wire of the bellows to the
ground wire, L2, L1 of the wiring seat respectively. The bellows is stretched out
from the outlet of the bellows and pressed on the upper cover by the wire clamp.
As shown below:
For 240V, connection ways as below:
Caution! In the event of any connection the safety
Caution! Voltage of heating elements 240V
Connection Diagram
wire must be connected to the terminal
Green wire connect to of the electric oven
Red wire connect to L2 of the electric oven
Black wire connect to L1 of the electric oven
Blue Green/Yellow
Wiring port baffle
(844) 538-7890 support@gaslandchef.com
www.gaslandchef.com
3330-A Marathon Ct Charleston, SC 29418
11
www.gaslandchef.com
To Next Page
Loading...
