To Next Page
M
matthew90Sep 1, 2025
What to do if my Gastroback 42636 Coffee Maker turns on but doesn't work?
- DdcannonSep 1, 2025
If your Gastroback Coffee Maker is on but stops operating, turn the machine off, wait for 60 minutes, and then turn it back on.
What to do if my Gastroback 42636 Coffee Maker turns on but doesn't work?
If your Gastroback Coffee Maker is on but stops operating, turn the machine off, wait for 60 minutes, and then turn it back on.
Why is my Gastroback 42636 Coffee Maker espresso only dripping?
If the espresso only drips from the portafilter spouts with restricted flow, it could be due to several reasons: * The coffee is ground too finely: Use a slightly coarser grind. * Too much coffee in the filter basket: Lower the dose of coffee. * Coffee tamped too firmly: Tamp between 15-20kgs of pressure. * The Dual Wall filter basket may be blocked: Use the fine pin on the cleaning tool to clear the outlet hole on the underside of the filter basket.
What to do if Gastroback 42636 says 'FILL TANK' when full?
If the LCD display on your Gastroback Coffee Maker shows 'FILL TANK' even when the water tank is full, it indicates that the water tank is not fully inserted and locked into position. Push the water tank in fully and lock the latch closed.
How to fix coffee not being hot enough in my Gastroback Coffee Maker?
If your coffee isn't hot enough, it could be due to a few reasons: * Cups not preheated: Rinse cups under the hot water outlet and place them on the cup warming tray. * Milk not hot enough (if making a cappuccino or latte, etc.): Heat milk until the base of the jug becomes hot to the touch. * Coffee beans are stale: Buy freshly roasted coffee with a 'roasted on' date.
Why is my Gastroback 42636 Coffee Maker espresso running out too quickly?
If espresso runs out too quickly and/or the pressure gauge isn't reaching 9 bar, it could be due to: * The coffee being ground too coarse: Use a slightly finer grind. * Not enough coffee in the filter basket: Increase the dose of coffee and use the RAZOR™ dosing tool to trim off excess coffee after tamping. * Coffee not tamped firmly enough: Tamp between 15-20kgs of pressure. * If these suggestions don't help, check the machine by placing an EMPTY Dual Wall filter basket into the portafilter (either 1 CUP or 2 CUP) and pressing the MANUAL button. If the pressure gauge reads over 5 bar, the machine is OK. Ensure the correct dose by using the RAZOR™ dosing tool. If the dose is correct, make the grind finer. If the pressure gauge reads below 5 bar, contact Customer Service.
Why won't water flow from the group head of my Gastroback 42636?
If water does not flow from the group head, it could be due to several reasons: * The machine has not reached operating temperature: Allow time for the machine to reach operating temperature. The POWER light will stop flashing when the machine is ready. * The water tank is empty: Fill the tank. * The water tank is not fully inserted & locked: Push the water tank in fully and lock the latch closed.
Why does the Steam LED flash on my Gastroback Coffee Maker when turned on?
If the Steam LED flashes when the machine is turned On, the Steam Lever is Open. Move the Steam Lever to the CLOSED position.
How to get crema with Gastroback Coffee Maker?
If your Gastroback Coffee Maker is not producing crema, it could be due to stale coffee beans. Try buying freshly roasted coffee with a “roasted on” date. Also, if you're using pre-ground coffee, make sure you are using Dual Wall Filter Baskets.
Why is espresso running too fast on my Gastroback Coffee Maker?
If espresso runs out too quickly from your Gastroback Coffee Maker, and the pressure gauge isn't reaching 9 bar, it could be due to several reasons. The coffee might be ground too coarsely, so try using a slightly finer grind. You may not be using enough coffee in the filter basket, so increase the dose and use the RAZOR™ dosing tool to trim off any excess after tamping. Also, ensure the coffee is tamped firmly enough, applying between 15-20kgs of pressure.
How to fix no steam on Gastroback Coffee Maker?
If your Gastroback Coffee Maker isn't producing steam, the steam wand may be blocked. Try using the pin on the cleaning tool to clear any blockages. If the wand remains blocked, remove the tip using the spanner from the cleaning tool and soak it in hot water.
Dual Stainless Steel Boilers for simultaneous milk texturing and espresso extraction.
Electronic PID Temperature Control for precise water temperature to +/- 1°C.
Machine Preparation: Remove and discard all labelling and packaging materials. Clean parts and accessories.
Initial Start Up: Fill tank, check levers, press POWER ON. Flushing cleans system before first coffee.
Press POWER to switch ON. POWER button flashes, LCD displays temperature. Ready when buttons illuminate.
Press 1 CUP to extract single shot (approx. 30ml) using low pressure pre-infusion.
Press 2 CUP to extract double shot (approx. 60ml) using low pressure pre-infusion.
Press MENU to flash SHOT VOL, press 1 CUP to start/stop extraction to set volume.
Press MENU to flash SHOT VOL, press 2 CUP to start/stop extraction to set volume.
Hold 1 CUP to deliver water at full pressure, bypassing pre-infusion for purging.
Hold 2 CUP to deliver water at full pressure, bypassing pre-infusion for purging.
Wipe basket, dose coffee, tamp firmly (15-20kg) for consistent espresso.
General| Brand | Gastroback |
|---|---|
| Model | 42636 |
| Category | Coffee Maker |
| Language | English |
