Why does my GASTRON GTD-2000Ex Gas Detectors show FAULT5 '+24V LOW'?
If the GASTRON Gas Detectors display a FAULT5 '+24V LOW' error, it indicates that the input power supply is less than 17V or there is a defective ADC for the Transmitter.
How to fix FAULT1 "SEN EMPT" on GASTRON GTD-2000Ex Gas Detectors?
If your GASTRON Gas Detectors shows a FAULT1 "SEN EMPT" error, it means there is a defective connection of the sensor module. The suggested solution is to replace the sensor.
What to do if GASTRON GTD-2000Ex shows FAULT8 "SEN HUNT"?
If your GASTRON Gas Detectors displays a FAULT8 "SEN HUNT" error, it could be due to a defective output state of the sensor or noise in the input power supply. The suggested solution is to replace the sensor.
What causes FAULT2 "SEN HIGH" in GASTRON Gas Detectors?
If your GASTRON Gas Detectors shows a FAULT2 "SEN HIGH" error, it indicates a defective sensor module or a defective ADC for the Transmitter board. The suggested solution is to replace the Transmitter board.
What does FAULT3 "SEN LOW" mean on GASTRON Gas Detectors?
If you see a FAULT3 "SEN LOW" error on your GASTRON Gas Detectors, this indicates a defective sensor module or a defective ADC for the Transmitter board. Replace the Transmitter board to resolve this issue.
How do I resolve FAULT7 "H/W REV" on GASTRON GTD-2000Ex?
If your GASTRON Gas Detectors shows a FAULT7 "H/W REV" error, it means that there is a defective MPU inside the transmitter. The suggested solution is to replace the Transmitter Main Board.
What does FAULT4 "EROM ERR" mean on GASTRON GTD-2000Ex Gas Detectors?
If your GASTRON Gas Detectors display a FAULT4 "EROM ERR" error, it indicates a defective EEPROM for the transmitter board. You can try to revise and recalibrate the Parameter after enforcement of factory initialization. If the same phenomenon occurs, replace the Sensor Unit.
What causes FAULT6 "ADC FAIL" on GASTRON Gas Detectors?
If your GASTRON Gas Detectors displays a FAULT6 "ADC FAIL" error, it indicates a defective ADC for the transmitter.
Technical parameters like measuring type, range, accuracy, certification.
Input voltage, wattage, analog output, signal transmission, EMC protection.
Procedures for zero and span calibration of the gas detector.
Detailed steps for performing zero calibration and success/fail criteria.
Detailed steps for performing span calibration and success/fail criteria.
Configuration settings for alarm levels, types, and latching.
List of common fault messages, conditions, and causes.
List of common problems and recommended coping measures.
General| Brand | GASTRON |
|---|---|
| Model | GTD-2000Ex |
| Category | Gas Detectors |
| Language | English |
To Next Page
