To Next Page
A
Ashley DavenportAug 17, 2025
What to do if my GASTRON Gas Detectors show a defective sensor module?
- SSheena GonzalezAug 17, 2025
If your GASTRON Gas Detectors display 'Defective Sensor Module', you should replace the sensor.
What to do if my GASTRON Gas Detectors show a defective sensor module?
If your GASTRON Gas Detectors display 'Defective Sensor Module', you should replace the sensor.
What to do if GASTRON Gas Detectors display a defective transmitter board ADC?
If your GASTRON Gas Detectors are showing 'Defective Transmitter Board ADC', you should replace the transmitter board.
What to do if GASTRON Gas Detectors show a defective transmitter board EEPROM?
If the GASTRON Gas Detectors display 'Defective Transmitter Board EEPROM', you should first perform a factory initialization, correct the parameters, and recalibrate. If the problem persists, replace the sensor unit.
What to do if GASTRON Gas Detectors have poor sensor output status?
If your GASTRON Gas Detectors indicate 'Poor Sensor Output Status', the suggested solution is to replace the sensor.
What to do if GASTRON Gas Detectors show a defective MPU inside transmitter?
If your GASTRON Gas Detectors display 'Defective MPU inside Transmitter', the suggested solution is to replace the transmitter main board.
Why do GASTRON Gas Detectors display +24V LOW?
If your GASTRON Gas Detectors display '+24V LOW', it may be due to input power being below 17V or a defective transmitter ADC.
Why do GASTRON Gas Detectors display SEN HIGH?
If your GASTRON Gas Detectors show 'SEN HIGH', this could be caused by a defective sensor module or transmitter board ADC.
Why do GASTRON Gas Detectors display SEN LOW?
If your GASTRON Gas Detectors show 'SEN LOW', this could be caused by a defective sensor module or transmitter board ADC.
Why do GASTRON Gas Detectors display ADC FAIL?
If your GASTRON Gas Detectors display 'ADC FAIL', it indicates a defective Transmitter ADC.
Why do GASTRON Gas Detectors display EROM ERR?
If your GASTRON Gas Detectors display 'EROM ERR', this is due to a defective Transmitter board EEPROM.
General| Ingress Protection | IP65 |
|---|---|
| Alarm Type | Audible and Visual |
| Response Time | Within 30 seconds |
| Operating Temperature | -20°C to 50°C |
| Operating Humidity | 0 to 95% RH (non-condensing) |
| Power Source | 24V DC |
| Target Gas | Combustible gases |
| Sensing Method | Catalytic combustion |
