Gatekeeper Systems CartManager XD+ User Manual

CartManager XD+ Owner-Operator Training and Troubleshooting Guide Page 16
Quarterly Maintenance:
1. Clean the battery cables and connectors:
• Put on rubber gloves and safety goggles.
• Disconnect the battery cables from one of the main batteries and remove the battery from the CartManager
XD+.
• Clean the terminals with a solution of 1 tbsp of baking soda to one cup of warm water.
• Use a wire brush or medium sandpaper to remove any corrosion or buildup.
• While the battery is out, buff the cable connectors down to bare metal with sandpaper, a wire brush or a wire
wheel.
• Use a clean dry cloth to wipe the connectors and terminals.
• Replace the battery, reconnect cables and tighten all connections.
• Spread a thin layer of waterproof grease over the terminals and connectors.
• Replace the plastic terminal covers.
• Repeat this process for the next battery.
2. Check each battery for leaks or cracks in the casing. If there is any fluid leaking from a battery, it should be
replaced immediately. See Replacing the CartManager XD+ Batteries on page 28.
3. Check all fasteners and hardware. Tighten any loose items.
4. Apply axle grease to the rear swivel wheel bearings.

Gatekeeper Systems CartManager XD+ Specifications

General

Brand	Gatekeeper Systems
Model	CartManager XD+
Category	Utility Vehicle
Language	English