EasyManua.ls Logo

GATEMASTER 900 HD - Warnings; Technical Characteristics

Default Icon
13 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Swing Gate Opener Manual
Warnings
Please read this instruction manual carefully before the installation of gate operator system.
A wired photo eye sensor must be installed for this gate operator to function properly
(UL325-2016)
This manual is exclusively for qualified installation personnel. We are not responsible for
improper installation and failure to comply with local electrical and building regulations.
* Be aware of the hazards that may exist in the procedures of installation and operation of
the gate-automated system. Besides, the installation must be carried out in conformity with
local standards and regulations.
* If the system is correctly installed and used following all the standards and regulations, it
will ensure a high degree of safety.
* Make sure that the gates work properly before installing the gate-automated system and
confirm the gates are appropriate for the application.
* Do not let children operate or play with the gate-automated system.
* Do not cross the path of the gate-automated system when operating
* Please keep all the control devices and any other pulse generator away from children to
avoid the gate-automated system being activated accidentally.
* Do not make any modifications to any components that is not in this manual.
* Do not try to manually open or close the gate before you release the gear motor.
* If there is a failure that cannot be solved and is not mentioned in this manual, please
contact qualified installation personnel.
* Do not use the gate-automated system before all the procedures and instructions have been
carried out and thoroughly read.
* Test the gate-automated system weekly and have qualified installation personnel to check
and maintain the system at least every 6 months.
* Install warning signs on the both sides of the gate to warn the people in the area of
potential hazards.
Technical Characteristics
Motor: 24VDC motor with mechanical release
Gear type: Worm gear
Max absorbed power: 144W
Peak thrust: 3500N
Nominal thrust: 3000N
Stroke length: 300mm
Power supply: 110VAC converted to 24VDC with
built in transformer
Nominal input power: 2A
Maximum operating current: 5.5A for maximum 10
seconds
Maximum gate weight: 500 lbs. per leaf
Maximum gate length: 14 ft.
Duty cycle: 20%