EasyManua.ls Logo

Gateway E-2300 - Replacing the System Battery

Gateway E-2300
134 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
55
www.gateway.com
Replacing the system battery
If the computer clock does not keep time or the settings in the BIOS Setup utility are not
saved when you turn off your computer, replace the system battery. Use a battery of the
same size and voltage as the original battery that was in your computer.
To replace the battery:
1 Shut down your computer.
2 Open the case by following the instructions in “Opening the case” on page 46.
3 Locate the old battery on the system board and note its orientation. You will need
to install the new battery the same way.
4 While pushing down on the battery release tab, place the edge of a small flat-head
screwdriver under the battery and lift the battery up until it pops out of the socket.
Warning Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended by the
manufacturer. Dispose of used batteries following the manufacturers
instructions.

Table of Contents

Related product manuals