83
www.gateway.com
Example router-based wired Ethernet network
The following is an example of a wired Ethernet network. The network is made up of a
router, a cable or DSL modem, your computers, and cables connecting each of these
components. The router is the central control point for the network. Attached to the router
are all of your computers or Ethernet-ready devices. Also connected to the router is a cable
or DSL modem that provides access to the Internet.
Equipment you need for a router-based wired Ethernet network
For a wired Ethernet network you need:
■ Two or more computers with Ethernet jacks
■ One router
■ One broadband Internet connection (optional)
■ Ethernet cables connecting all of the network equipment
Tips & Tricks To add the ability to access a wireless Ethernet network to your wired
Ethernet network, connect an access point to the router or use a
router that has a built-in access point, such as the Linksys wireless
access point router with 4-port switch. For more information about
accessing a wireless Ethernet, see “Using a wireless Ethernet
network” on page 77.
Cable/DSL
modem
Router
To Next Page
Loading...
Need help?
General
