What to do if my Gaymar T/PUMP TP700 T/Pump will NOT turn on?
First, ensure the electrical cord is fully inserted into a properly grounded Hospital Grade receptacle. Then, visually inspect the power cord for any defects and replace it if necessary. If these steps don't resolve the issue, the membrane panel may be defective and need replacement. For a defective PC Board, refer to the troubleshooting steps for when the T/Pump will NOT heat.
What to do if my Gaymar T/PUMP TP700 T/Pump will NOT pump?
First, check that the water level is adequate; refill the reservoir with room temperature water to the proper level if it's low or empty. Next, check for power to the motor (TP650(C)/ TP700(C) - 120V ± 10% or TP702 - 230V ± 10%) across the motor connections. If power is present, inspect the motor, impeller magnet, and magnet driver assembly for defects. Replace the motor if the fan isn't spinning when plugged in and in run mode. Check the impeller for obstructions or replace the impeller magnet assembly. Ensure the screw holding the driver magnet to the motor shaft is tight.
Why is the warning indicator ON when my Gaymar T/PUMP TP700 Medical Equipment is in Standby Mode?
The unit likely shut down due to an over-temperature condition. To resolve this, empty the reservoir and refill it with room temperature water. Ensure all clamps are open. Then, press the On/Standby button and verify flow through the pad. The warning light should turn off within 5 minutes.
How to unlock temperature or therapy time buttons on Gaymar Medical Equipment (TP700 Series Only)?
If the temperature or therapy time buttons on your TP700 series Gaymar Medical Equipment are not working, it's possible they have been locked. To unlock them, simply press and hold the lock button for two seconds. If this does not work, the membrane panel may be defective and needs to be replaced.
Critical safety warnings for immediate hazards.
Important safety precautions to prevent injury or damage.
Advisories to prevent minor damage or operational issues.
Steps for disassembling the T/Pump reservoir.
General| Model | TP700 Series |
|---|---|
| Application | Therapeutic heating and cooling |
| Over Temperature Cutout | Yes |
| Sleeve Options | Multiple sizes available |
| Portability | Portable |
| Display | Digital display |
| Alarms | temperature |
To Next Page
