Pg 8
Babystepping Cheat Sheet
Lower
Extruder
Raise
Extruder
Change IncrementSave to
Memory
Too low and nozzle
is digging in the bed
causing damage.
Too high and
not adhering to
the bed
Correct height.
Sticks to bed just
enough.
Extruder
Extruder
Extruder
Extruder is too low Extruder is perfect Extruder is too high
As your print starts, click
“Babystep”.
You may have to raise or
lower up to 0.50 mm depend-
ing on settings and if your
nozzle has been changed. It
might take a few seconds to
see any change in height
Note
To Next Page
Loading...
