FEATURE INFORMATION
6-5
29) Power Factor Alarm Power Factor
Alarm
30) Frequency Alarm Frequency
Alarm
31) Breaker Discrepancy Alarm Breaker
Discrep. Alarm
32) Trip Coil Alarm Trip Coil
Alarm
33) MTM Communications Alarm MTM Comm.
Alarm
34) Phase Overcurrent Alarm Condition Reset Phase O/C Alarm
Reset
35) Ground Overcurrent Alarm Condition Reset Ground O/C
Alarm Reset
36) Overvoltage Alarm Condition Reset Overvoltage
Alarm Reset
37) Undervoltage Alarm Condition Reset Undervoltage
Alarm Reset
38) Analog Input Alarm Condition Reset Analog Input
Alarm Reset
39) Definite Time Alarm 1 Condition Reset Switch Alarm#1
Reset
40) Definite Time Alarm 2 Condition Reset Switch Alarm#2
Reset
41) Breaker Discrepancy Alarm Reset Breaker Alarm
Reset
42) Installation of the Access Jumper Access Jumper
Installed
43) Removal of the Access Jumper Access Jumper
Removed
44) Enable of Block Instantaneous Trip Block Inst.
Trip Enabled
45) Disable of Block Instantaneous Trip Block Inst.
Trip Disabled
46) Enable of Block Timed Overcurrent Trips Block Timed
Trips Enabled
47) Disable of Block Timed Overcurrent Trips Block Timed
Trips Disabled
48) Enable of Overcurrent Curve Adjustment Curve Adjust.
Enabled
49) Disable of Overcurrent Curve Adjustment Curve Adjust.
Disabled
50) Illegal Access to Setpoint Illegal
Setpoint Access
51) System Manual Reset System Manual
Reset
52) Control Switch to Remote Control Switch
to Remote
53) Control Switch to Local Control Switch
to Local
To Next Page
Loading...
