GE Multilin 565 - Page 42

4-14
Location Message Line Description
A 8.1
ACTUAL VALUES
DEMAND DATA
The actual values page 8 header. This page allows the demand metering
related data to be viewed.
Message A 8.2 will only appear if AMPS DEMAND is disabled in setpoints.
A 8.2
AMPS DEMAND
DISABLED
This message informs the user that Amps Demand has been disabled.
Messages A 8.3 to A 8.5 will only be shown if the Amp Demand feature has been enabled in setpoints.
A 8.3
PH-A PEAK DEMAND
1050 A
This message shows the peak amps demand value of phase A since the
last clearing of the function data.
A 8.4
PH-B PEAK DEMAND
1100 A
This message shows the peak amps demand value of phase B since the
last clearing of the function data.
A 8.5
PH-C PEAK DEMAND
1070 A
This message shows the peak amps demand value of phase C since the
last clearing of the function data.
A 8.6
CLEAR AMP DEMAND
DATA? NO
This message prompts the user if Demand Amps data is to be cleared. If
YES, data stored will be erased.
A 8.7
DATA CLEARED
LAST:AUG 04,1992
This message shows users when data was last cleared.
The following messages are only displayed if a Metering Transducer Module (MTM) has been connected to the 565/575, an
Option Card has been installed in the 565, and the communications has been enabled.
Message A 8.8 will appear only if the KW Demand feature has been disabled.
A 8.8
KW DEMAND
DISABLED
This message informs the user the KW Demand has been disabled.
Message A 8.9 will only appear if the KW Demand feature has been enabled.
A 8.9
PEAK KW DEMAND
65000 kW
This message shows the peak kW demand value since the last clearing.
A 8.10
CLEAR KW DEMAND
DATA? NO
This prompts the user if kW demand data is to be cleared. If YES, data
stored will be erased.
A 8.11
KW DEMAND DATA
CL'D:AUG 04,1992
This message shows the date when data was last cleared.
L
A
ACTUAL VALUES MODE - DEMAND DATA