GE Profile 22 - Final Setup: Plugging In and Leveling

48
SafetyInstructionsOperatingInstructionsInstallationInstructionsTroubleshootingTipsConsumerSupport
PLUGINTHEREFRIGERATOR
Before plugging in the refrigerator, make sure the ice
maker power switch is set to the O (o) position.
See the grounding information attached to the power
cord.
Note:The image can be dierent from your product.
PUTTHEREFRIGERATORINPLACE
Move the refrigerator to its nal location.
LEVELTHEREFRIGERATOR
The refrigerator can be leveled by adjusting the rollers
located near the bottom hinges.
Rollers have three purposes:
• Rollers adjust so the door closes easily when opened
about halfway. (Raise the front about 5/8” [16 mm]
from the oor.)
• Rollers adjust so the refrigerator rmly positioned on
the oor and does not wobble.
• Rollers allow you to move the refrigerator away
from the wall for cleaning.
To adjust the rollers:
• Turn the roller adjusting screws clockwise to raise
the refrigerator, counterclockwise to lower it. Use a
3/8” hex socket or wrench, or an adjustable wrench.
LEVELTHEDOORS
Adjust the refrigerator door to make the doors even at
the top.
To align:
• Using a 7/16” wrench, turn the door adjusting screw
to the right to raise the door, to the left to lower it.
Note:A nylon plug, imbedded in the threads of the pin,
prevents the pin from turning unless a wrench is used.
• After one or two turns of the wrench, open and close
the refrigerator door and check the alignment at the
top of the doors.