Installation:
1. Attach the coax cable from the antenna to
the power inserter “Antenna”
Power inserter must be used for the
antenna to work
2. Connect the attached coax cable from the
power inserter labeled “Receiver” to the
back of the TV
3. Connect the D/C plug from the power
adapter to the power inserter
6. Use your hammer and lightly tap in the
supplied drywall anchors until they are fl ush
with receptacle.
7. Use your Phillips screwdriver. Screw in
the screws provided until they stick out
about 1/16".
8. Mount the antenna onto the screws by
lining up the keyhole slots on the back of the
antenna with the screws.
a. Be sure you have routed the coax cable
in the direction you want the cable to go by
using the cable channel on the bottom of
the antenna.
To Next Page
Loading...
