About the automatic icemaker.
A newly installed refrigerator may take 2_2to 24 hours to begin making ice.
GEAppliances.com
Automatic Icemaker
Theicemakerwill produce seven cubes
per cycle-approximately 100-130 cubes
in a 24-hour period,depending on freezer compartment
temperature, room temperature, number of door openings
and other use conditions.
If the refrigerator isoperated before the water connection is
made to the icemaker,set the power switch in the OFF
position.
When the refrigerator has been connected
to the water supply,set the power switch
to the ON position.
Theicemakerwill fillwith water when it coolsto !5°F (-10°C).A
newly installedrefrigerator may take 12to 24 hoursto begin
making
icecubes.
Youwill hear a buzzing sound each time
the icemaker fills with water.
Throw away the first few batches of ice
to allow the water lineto clear.
Besure nothing interferes with the sweep
of the feeler arm.
When the bin fills to the levelof the feeler arm, the icemaker
will stop producing ice.
It is normal for several cubes to bejoined together.
If ice isnot usedfrequently, old icecubes will become cloudy,
taste stale and shrink.
Special note about dispenser models:
Some models have a tilt-out icebin.
Thebin can be tilted out us shown in the illustrations, and it
will hold itself up whileyou take ice out or turn the icemaker
power switch on and off. Besureto put the bin back in
place before closing the door.
To restore your ice level from an empty bucket stage, the
following steps are recommended:
O 12 hours after the first batch of icehas fallen into the bin,
dispense3 to/4 cubes.
O After an additional 6 hours, dispense
3 to 4 cubes again.
Thesestepswill restore your ice levelin
the shortest amount of time.
cemaKer
Switch =eeler Arm
(on some models)
Power
Switch cemaKer
Gree
Power L_gn_ FeelerArm
(on some models)
NOTE:
In homes with lower than average water pressure, you may
hear the icemaker cycle multiple times when making one
batch of ice.
15
To Next Page
Loading...
Need help?
General
