About the automatic icemaker. (cant) GEAppliances.com
Models with tilt out ice bin
To access ice and reach the
icemaker power switch:
O l_iftthe bin, then pull it
forward until the bin stops.
Accessing Ice and Reaching
the Power Switch on Dispenser
Models
There ore two types of ice storage bins
on dispenser models. One has a shelf above
the bin, the other does not.
Special note for models with tilt-out
ice bin:
Thesemodels have a tilt-out icebin.
Thebin can betilted out as shown in
the illustrations,and it will hold itself
up while you take ice out or turn the
icemaker power switch on and off.
Besure to put the bin back in place
before closing the door.
NOTE: In order to take full advantage of the tilt-
out ice bin, only store items on the shelf below
the ice bin that are no taller than the lowest
point on the bin.
Models with a shelf
above the ice bin
To access ice, pull the bin forward.
iiii
......................... i!i k
i i i
To reach the power switch, pull the
shelf straight out. Always be sure to
replace the shel_
O Lower the bin to access ice
or reach the power switch.
On some models,
to access ice or reach
the power switch:
/
_ _i _
O ull the bin forward until the
bin stops.
11-
O ower the bin to access ice
or reach the power switch.
Removing Ice Bin (dispenser models)
CAUTION:The ice bin is heavy when full.
Setthe power switch to the OFFposition
before removing the bin.
When replacing the bin, be sure to press
itfirmly into place. If it does not go all the way
back, remove it and rotate the drive
mechanism 1/4 turn. Then push the bin
back again.
Dispenser Models only
16
To Next Page
Loading...
Need help?
General
