Beforeyoucall forservice...
_ roubleshooting -tips
Save time and money/.Review the charts on the following
pages first and you may not need to carl for service.
SENSORWASH PossibleCauses WhatToDo
SensorWashindicator Washer is NOT in awashflu • This is nomlal. I_ightonly illuminates during washtills
light(onsomemodels) cycleor awarm rinse fill cycle and w;u'm rinse tills.
isnotilluminated
SensorWashwash The washeris in a cold rinse cycle .Thisisnomlal. The SensorWashtbamreis designed not
temperatureis incorrect to activate during a (old rinse (Ttle so that the (oldest
water available isused.
(ReviewSensorWash All the water in the water heater • W:tit until the water in the water heater is heated to the
in the About washer has been used correct temperature.
featuressection)
WATER Possible Causes What ToDo
Toomany suds Type of detergent • S_dt(h to a lower sudsing detergent brand and tolh)w
instal( tions on package.
Verysoft water = TU less detergent.
Too much detergent. • Measure your detergent (areflflly. Use less soap if you
have soft water, a smaller load, or a lightly soiled load.
Waterleaks Fill hoses or drain hose is * Make sure hose couuecdons are tight at timcets and make
hnproperly connected sure end of drain hose is correctly inserted in and secured
to &win tilt ility.
Household drahl may • Check household plumbing. You may need to call a
be clogged plumber.
Constant water pressure • Tighten hoses at the limcets and turn the water offafter
to the fill hoses at the each use.
water source * Check con(htion of the fill hoses; they mW need
repla( ement after 5 years.
Using too much detergent ° Use less detergent. Use less soap if you have soil water, a
iu washer smaller load, or a lightly soiled load.
Watertemperature Control is not set properly * Che(k water temperature (onnol and a(!iust.
isincorrect
Water supplyis turned off * Turn both hot and (old Lintels fiflly on and make sure
or improperly connected hoses are connected to correct faucets.
Water valve screens are * Turn off the water source and remove the water connection
stopped up hoses flom the upper back of the washer. Use a brash or
toothpick to clean the screens in the machine. Reconnect
the hoses and mm the water ha& on.
House water heater is * Make sure house water heater is delivering water
not set properly at 120°F.-140°F.(48°C.-60°C.).
Water won'tdrain Drain hose is khlked or * Straighten drain hose and make sure washer is not sitting
improperly connected on it.
• Top of drain outlet should be less than 8 ft. above floor.
72
To Next Page
Loading...
