GE GTW460ASJWW - User Manual

80 pages

Save Page as PDF

To Next Page

To Next Page

Loading...

GEAppliances.com

Washers

49-90549 06-15 GE

Safety Instructions ..........2, 3

Operating Instructions

Care and Cleaning

of the Washer .................... 13

Features ..........................12

Loading and Using

the Washer ...................... 11

Operating instructions .........4–10

Installation Instructions . 14–18

Troubleshooting Tips .....19–24

Consumer Support

Consumer Help Indicator .........10

Consumer Support ................26

Parts and Accessories. . . . . . . . . . .3, 26

Warranty ..........................25

G002

Printed in the United States

Write the model and serial

numbers here:

Model # _____________

Serial # ______________

You can find

them under

the lid of the

washer.

*

As an ENERGY STAR

®

partner,

GE has determined that this

product meets the ENERGY STAR

®

guidelines for energy efficiency.

Owner’s Manual &

Installation Instructions

GTW485*

GTW460

Table of Contents

Other manuals for GE GTW460ASJWW

Service Manual81 pages

Reference Guide1 page

Questions and Answers

K
kimberlycordovaAug 13, 2025
Why is my GE GTW460ASJWW Washer leaking water?
- C
  Christian GrahamAug 13, 2025
  Several factors can cause water leaks in your GE Washer. You might be using too much detergent, or the wrong type. Try using less detergent, especially if you have soft water. Ensure your fill and drain hoses are properly connected and tightened at the faucets, with rubber washers installed. Also, check your household plumbing for clogs, and make sure the drain hose isn't rubbing against the wall. Finally, ensure constant water pressure doesn't stress the fill hoses, and consider replacing them every 5 years.
A
Ashley HaynesAug 16, 2025
What to do if there is low water flow in my GE GTW460ASJWW Washer?
- D
  davidbaileyAug 16, 2025
  If you're experiencing low water flow in your GE Washer, the water valve screens might be clogged. Turn off the water supply and disconnect the hoses from the back of the washer and the faucets. Clean the hose screens and the screens in the machine using a brush or toothpick. Reconnect the hoses, turn the water back on, and check for leaks.
H
Holly TravisAug 20, 2025
Why does the water level seem low in my GE Washer?
- B
  Betty WrightAug 21, 2025
  If the water level seems low in your GE Washer, it's likely normal. This high-efficiency washer is designed so that water may not cover the top level of the clothes.
K
Kimberly WhiteheadAug 25, 2025
How to deal with a small amount of water remaining in the dispenser of GE GTW460ASJWW Washer?
- D
  Dana Smith MDAug 26, 2025
  It is normal for a small amount of water to remain in the dispenser of your GE Washer after the cycle.
W
William ThomasAug 28, 2025
Why does my GE GTW460ASJWW have too many suds?
- C
  Christina TuckerAug 28, 2025
  Excessive suds in your GE Washer can be due to several reasons. If you have soft water, use less detergent. You might also be using too much detergent in general, so measure carefully. Consider switching to a High Efficiency detergent.
S
Sarah DuarteSep 1, 2025
Why does the water temperature seem incorrect on my GE GTW460ASJWW Washer?
- G
  gnormanSep 1, 2025
  Several factors can affect the water temperature in your GE Washer. Modern detergents work well with cooler water for energy efficiency. Ensure both hot and cold water faucets are fully on and properly connected, noting the “H” and “C” markings on the water valves. Clean any blockage in the water valve screens. Note that the washer may optimize temperature, adding cold water even when hot is selected. Lastly, ensure your house water heater is set between 120°F–140°F (48°C–60°C).
S
Sandra PowellSep 5, 2025
Why is water siphoning out of my GE Washer?
- H
  Heather RamosSep 5, 2025
  If water is siphoning out of your GE Washer, the drain standpipe might be too low, or the hose is inserted too far into it. The drain hose must be at least 32 inches high between the washer and the drain pipe. Use an anti-siphon clip.
A
Amy FullerSep 8, 2025
Why is there a short spray and delay after pushing the Start button on my GE GTW460ASJWW?
- B
  Brian HigginsSep 8, 2025
  This is normal operation for GE Washers. This can occur if the lid was opened and closed between cycle selection and start.

GE GTW460ASJWW Specifications

General

Style	top load
Color	white, white on white
Washer Capacity	4.2 cubic feet
Max Spin Speed	700 revolutions per minute
Spin Speeds	1
Number of Cycles	14
Cycle Selections	normal, light, heavy, delicates, casuals, speed wash, drain & spin, active wear, bulky items, jeans, towels/sheets
Options	auto soak, 2nd rinse, extra spin, 2nd rinse + extra spin, deep rinse
Temperature Settings	6
Temperature Selections	tap cold, cold, cool, colors, warm, hot
Soil Levels	extra heavy, heavy, normal, light, extra light
Internal Heater	no
Control Panel	electromechanical
Delay Start / End	yes
Child Lock	no
Cycle Signal	yes
Interior Light	no
Steam	no
Smart Home	no
Annual Energy Consumption	284 kilowatt hours
Voltage	120 volts
Current	10 amperes

Weight and Dimensions

Depth	27 inches
Height	44 inches
Width	27 inches
Net Weight	138 pounds

Related product manuals

Preview: GE GTW460

Preview: GE GTW465

Preview: GE GTW490

Preview: GE GTW485

Preview: GE GTW491

GE GTW485ASJ_WW

GE GTW490ACJ_WS

GE GTW485 series