EasyManua.ls Logo

GE 2200 - Page 14

GE 2200
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Beforeyou call forservice...
(con) PERFORMANCE Possible Causes What To 0o
Pilling Result of normal wear on * \.\qlile dlis is not ( aused by I he washer you (;Ill sl()w llle
poly-cotton blends and pilling pro(ess by washing garments inside out.
fuzzy fabrics
Snags, holes, tears, rips Pins, snaps, hooks, sharp Fasten snaps, hooks, buttons, and zippers.
or excessive wear buttons, belt buckles,
zippers, and sharp objects " Remox e loose items like pins, obje(ts ill po(kets
left in pockets and sharp barons.
" Turn knits (whi(h snag easily) inside out.
Undiluted chlorine bleach * Check bleach package instructions fi)r proper amount.
= Nexer add undiluted bleach to wash or allow ( lothes
to come ill (:onta(t with undthlt ed blea(h.
Chemicals llke hair bleach * Rinse items that may haxe chemicals on diem before
or dye, permanent wave washing.
solution
Wrinkling Improper sorting * Avoid mi_ug hea_ T items (like work (lodles) whh
light items (like blouses).
TI y a fhbri( sotlener.
Overloading or = Load your washer st) (:It)tiles ha'_e enough roocn
incorrect water level to move fleely.
Incorrect wash and * Match Cy(le sele(uon to tile type of_i_bri( you are
dry cycles washing (espe(ially for easy (are loads).
Repeated washing in " Wash ill warm or cold water.
water that is too hot
NOISE Possible Causes What To Be
Washer is noisy Washer is uneven * To level tlle fiom of tile _asher, adjust tile flont leveling
legs by rotating the indMdual leg ill tile proper direction
tbr up or down. To level ba(:k of washer, litl ba(:k of
me(blue 4" and set down.
Washer load is " Push tile Cy(le knob ill to stop tile washer, open tlle lid
unbalanced aud redistribme die load ex enly. Close tile lid aud restan.
Shipping rod is still assembled * To rerno., e shipping rod flom washer, pull yellow tag and
in unit attached rod fiom d_e bottom right hand side of washer.
) ,,,,.
Washer is sitting too close * Iull washer away fl()m tile wall; about 4 is needed.
to wall (causes knocking
during cycle)
OTHER Possible Causes What To0o
I.abels on the exterior Occasionallythe adhesive * Use a hair (hyer set at tile lowest heat setting, direcrng
of the washer will not used on the labels does tile air at tile label fi)r a short amount of time. This _x411
peel off cleanly not release clearly release tile adhesix e easily, wid_om damaging die surthce
()f the wa slier.
/4

Related product manuals