TheAgitator Cap or Fabric Softener Dispenser (depending on model)
Theagitatorcapfits into the top of the ['j] Add water to dispenser until it reaches
agitator. Ifit accidentally comes off, simply _ tile maximum fill line.
put it back on.
Thefabricsoftenerdispenserautomatically
releases liquid fabric softener at tile
proper time during the (),(le.
Donot stopthewasherduringthe fkst spin.
Thiswill causethedispensertoemptytoo soon.
Touse,follow thesesteps:
[-_ Make sure dispenser is securely
attached to agitator.
[_U se only liquid fabric softener. Pour
into dispenser, using amount
recommended on package.
Neverpourfabricsoftenerdirectlyonclothes.
/t maystain them.
Donot pour anything into the agitatorif flTe
agitator cap or dispenser is removed.
Separate for cleaning.
Cleaning the Fabric Softener Dispenser (onsome models)
Ff] Remove the dispenser from tile top of the agitator.
[_ Separate tile dispenser (up fiom tile (over by g_vlsping tile top and pushing down on
the inside of the cup with your fingers. Dispenser cup x_411pop flee fiom the cover.
t-j] To (lean the dispenser, soak both the dispenser (up and the dispenser (over in the
fi)llowing solution:
• 1Uggallon(3.8 liters)warmwater
• 1/4cup (60m/)heavydutyliquid detergent
• I cup(240m/)bleach
[_]If necessatT, loosen builch_p xdth a clean, soti (loth _dier soaking. Do not use a stiff
brush; you may roughen tile sudilce of the dispenser.
[] Rinse and reassemble dispenser, Place dispenser back on the agitator,
To Next Page
Loading...
