GE 24116 - 4 - Device Universal Remote User Manual

7
Direct Code Entry
1. Press and hold the SETUP button until the red
indicator stays on, then release the SETUP button.
2. Press and release the desired mode button (TV,
DVD, etc.). The red indicator blinks, then stays lit.
3. Enter the 4-digit code from the code tables (on
separate sheet). Note: After a valid code entry, the
red indicator turns off. For an invalid code, the red
indicator flashes.
4. With your device on, press CHAN UP. If the device
responds, no further programming is required.
Note: If some buttons do not operate your
equipment, try one of the other codes for your
brand.
Write your codes down here for easy reference later.
Device Device stored Code
TV TV
DVD
CBL/SAT
DVR/AUX

GE 24116 - 4 - Device Universal Remote Specifications

General

Brand	GE
Model	24116 - 4 - Device Universal Remote
Category	Remote Control
Language	English