8
Code Search
If your product does not respond after you have tried
all the codes for your brand, or if your brand is not
listed, try searching for your code by following these
steps.
1. Manually turn on the device (TV, DVD, etc.) to be
controlled.
2. Press and hold the SETUP button until the red
indicator stays on, then release the SETUP button.
3. Press and quickly release the desired mode button
(TV, DVD, etc.). The red indicator blinks off once.
4. Press the CHAN UP button repeatedly (up to 300
times) until the device to be controlled changes
channel. The red indicator blinks off with each
button press. If you accidentally overshoot the
code required, press the CHAN DOWN button
to backtrack through the library until the device
changes channel. Pressing CHAN UP changes
direction to forward again.
5. Press and release ENTER to install the code.
Most users store DVD codes under the DVD button,
Cable codes under CABLE, etc. If (for example) you
want to store a DVD code under CABLE, first follow
the procedure for Direct Code Entry (previous page)
and press CABLE in step 2 of Direct Code Entry, then
enter ANY DVD code in step 3 of Direct Code Entry.
Then follow the steps for Code Search on the previ-
ous page. Note: If the device does not have a CHAN
UP button, use PLAY (DVD only) or ON-OFF instead.
Code Search starts from the currently stored 4-digit
number under that mode.
To Next Page
Loading...
Need help?
General
