PREPARATION
(continued)
Refrigerator Location
Clearances
Do
not install refrigerator where temperature will
Allow the following clearances for ease of
go
below
60”F.
because it will not run often enough
installation, proper air circulation and plumbing
[0
maintain proper temperatures.
and electrical connections:
Do install it on a floor strong enough to support it
Sides
3/4”
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
.
fully loaded.
Top . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1“
Also iee Energy-Saving Tips.
Back . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
]
“
If refrigerator is to be
insta]led
against
a
wall on the
hinge
side.
allow
172”
for-
door-
clearance.
Rollers/Leveling Legs
Some models have adjustable
rollers that allow you to move
the refrigerator
away
from
the
wfill
for
cleaning: other
models
lla~e
adjustable leveling legs.
Rollers or
legs
should
be
set
so the
refrigerator is firmly
posiliond
on
the
floor
and
the
front
is
raised just
enoL[gh
that
the
door~
c]ose
easily
when
opened
tiboul
halfway.
I
w
II
L
A
‘$+
Turn the
two
front
roller
adjusting
icrews
or four
comer
Ieve
1
i
ng
legs
clockwise to raise
the
r-efrigerator.
counterclockwise to
]ower
it.
When adjusting rollers or
leveling legs for proper door
closure, we recommend that the
bottom front edge
of the cabinet be
approximately
3/4”
from the
flOOI-.
If your refrigerator has a
base grille, you
can
turn the
adjusting screws through
openings in the grille.
If you would rather remove the
base grille,
g-asp
the bottom of the
gri]]e
and pull
i[
out.
To replace the base grille, line up
the clips on the back of the grille
with
the
openings in the baseplate
and
push
the
grilie
forward
until
it
snaps
into place.
Water Supply to
Icemaker
If
your
r-efr-igerator-
ha$
an
icernaker,
or if you plan to add an
icernaker
later,
the
icemakcr ~ill have to be connected to a cold water line. A water supply kit
contfiinin:
copper tubing, shut-off valve, fittings and instructions is available
at
extra
cost from your dealer. There should be sufficient tubing for the
iccmaker
from
the
cold
water
supply to allow you to move the refrigerator out
from the
wall
se~eral
feet (approximately 9 feet of 1/4” copper tubing in three
1
()” diameter
-
coi
Is
).
.
To Next Page
Loading...
Need help?
General
