16
Registration (Link Cordless Handset)
Registration links the base to a cordless handset. Once a handset is
registered it can use the base’s phone connection. A cordless handset will
not operate until it is registered to the base. During the registration process,
keep the handset near the base.
1. Press the FLASH/PROGRAM button on the base until
LINK HANDSET?
shows in the display. 2NO is the default setting.
2. Press the 1 number key or press the REVIEW or NEXT button on the base
to scroll to 1YES.
3. Press FLASH/PROGRAM on the base to confirm handset is linked to the
base. WAITING HANDSET REGISTRATION shows in the display.
4. Press the flash/program button on the handset until LINK BASE shows in
the display. NO is the default setting.
5. Press CID/VOL (or) button on the handset to scroll to YES.
6. Press flash/program on the handset again to confirm. You will hear a long
confirmation tone when the handset is successfully linked to the base.
Default Setting
NOTE:
This setting may be made on both the base and the cordless handset,
independent of each other.
1. Press the FLASH/PROGRAM button until DEFAULT SETTING or DEFAULT
shows in the display. 2NO is the default setting.
2. Press 1 or 2 on the cordless handset or base touch-tone pad or use the
REVIEW or NEXT button on the base or the CID/VOL (
or) button on
the handset to scroll to 1YES or 2NO.
NOTE: If you choose “YES ” all settings in the programmable menu return to
factory defaults except day and time.
3. Press FLASH/PROGRAM again to store your selection.
To Next Page
Loading...
