8
Programming Your Remote
Auto Code Search
The Auto Code Search, searches automatically through
all of the codes stored in this remote. Read all the
following steps prior to starting the auto code search
as you will need to be prepared to lock-in the proper
code when found.
1. Manually turn on the device you wish
to control.
2. Press and hold the SETUP button
until the red indicator light stays on
(approximately 2 seconds) and then
release the button.
3. Press and release the desired device
button on the remote (TV, DVD, CBL).
The red indicator will blink once and
then remain on.
4. Point the remote at the device and press
and release the POWER button (for TV)
or PLAY button (for DVD, VCR, etc.) to
start the search. The red indicator will
flash (approximately every 2 seconds) as
the remote searches. Note: The remote
must be pointed at the device for the
duration of this search.
5. Place your finger on the #1 button so
you are prepared to lock-in the code.
6. When the device shuts off or begins
playing, press the #1 button to lock-in
the code. The red indicator light will
turn off. Note: You have approximately
two seconds after the device shuts off or
begins playing to lock-in the code.
To Next Page
Loading...
Need help?
General
