GE 29586 - Remote Access; Accessing and Controlling the Answerer Remotely

34
Remote Access
You can access your answerer from any touch-tone phone from another location
by entering your 3-digit security code (the default security code is 1 2 3, but you can
change it.) Be aware that remote functions do not work with rotary or push-button
pulse-dialing phones.
To access your answerer:
1.
Call your telephone number.
2. After you hear the beep that follows the greeting, enter your 3-digit security code.
The unit conrms your code with a beep. To bypass the greeting, you can enter
your 3-digit security code any time while the greeting is playing.
The unit waits for a remote command for 20 seconds after the correct security code
has been entered. Menu selections can be made while the menu is playing.
NOTE: The unit answers on the 10th ring when it is turned off or the
memory is full. To access the answerer, enter the 3-digit security
code after the beep. If memory is full, play messages and erase
some of them to restore memory.
NOTE: After the unit plays the remote menu, it waits 20 seconds for
a command, then disconnects.
Remote Access Commands
Play messages 2
Repeat messages (during message playback) 1
Skip to next message (during message playback) 3
Erase message (during message playback) 0
Stop playback(during message playback) 2
Turn answerer On/Off 4
Review menu again 7