35
Message Indicators
The following special messages indicate the status of a message or the unit:
00 CALLS The call r
ecord log is empty.
UNKNOWN CALLER The incoming call does not hav
e Caller ID service or their
service area is not linked to yours. If UNKNOWN NAME
appears along with a calling number, the name information for
that number was not available.
BLOCKED CALL The caller is r
egistered as “Private Number” and the Caller ID
information is withheld.
ERROR Caller information has been interr
upted during transmission.
START/END Indicates y
ou are at the beginning or the end of the call record
log.
MEMO The message has been r
ecorded as a memo.
Troubleshooting Guide
Telephone Solutions
No dial tone
•
Check the hook switch to make sure it pops up.
Won’t dial out
•
Make sure the tone/pulse setting is programmed correctly.
Phone doesn’t ring
•
Check the ringer volume.
• Could have too many phones on one line.
(See FCC registration information regarding REN)
Low handset or speaker volume
•
Check the volume settings.
To Next Page
Loading...
