5
INSTALLATION
3. Connect the small end of the power supply into the
POWER 9V AC jack on the back of the answerer. Plug
the other end into an AC power outlet. The unit beeps 3
times and is ready for setup or to answer calls with the
default greeting and settings.
1. Plug the telephone line cord into a modular wall jack.
2. Connect the telephone line cord from your tele-
phone into the jack on the back of the answerer
marked PHONE. (You don’t have to connect your
telephone in order for the answerer to record
incoming messages.)
INSTALLATION INFORMATION
• Never install telephone wiring during
a lightning storm.
• Never touch uninsulated telephone
wires or terminals, unless the
telephone line has been discon-
nected at the network interface.
• Use caution when installing or
modifying telephone lines.
CAUTION: Only use the Thomson 5-2434A (white)/5-2418A (black) power supply that
was packed with this unit. Using other power supplies may damage the unit.
To Next Page
Loading...
Need help?
General
