16
c) Ground the 75 OHM Grounding Block: Connect
a #8 aluminum or #10 grounding wire to a screw
terminal provided on the 75 ohm grounding block.
Connect the other end of the wire to an acceptable
building ground location. Refer to Step a) above for
acceptable building grounding locations.
Be sure to double check all your connections after
your installation is complete. Ensure there are good
electrical connections of your grounding wires and
coax cables. See Fig. 6d below for an example of a
properly grounded antenna installation.
Fig. 6d
If you are unsure how to properly ground your antenna,
contacta professional installer in your area.
To Next Page
