20
Zoneline
Doesn’t Start
Zoneline Does Not
Cool or Heat as it
Should
The unit is unplugged • Make sure the Zoneline plug is
pushed completely into the outlet.
The fuse is blown/circuit • Check the house fuse/circuit breaker
breaker is tripped box and replace fuse or reset the
breaker.
The unit is waiting for the • This is normal. The Zoneline will start
compressor overload again after it resets.
protector to reset
Problem Possible Causes What to Do
Airflow is restricted • Make sure there are no curtains, blinds
or furniture blocking the front of the
Zoneline.
The temp control may • Turn the control to a lower or higher
not be set high or low number.
NOTE: The temperature limiter may
enough
be limiting the temperature range.
The air filter is dirty • Clean the filter at least every 30 days.
The room may have been • When the Zoneline is first turned on
hot or cold you need to allow time for the room to
cool down or warm up.
Air is escaping • Set the vent control in the
CLOSE
position.
If Something Goes Wrong
Before you call for service
To Next Page
Loading...
Need help?
General
