1.1.14 Control Terminals
All control cable terminals are located underneath the terminal cover in front
of the frequency converter. Remove the terminal cover using a screwdriver.
NB!
See back of terminal cover for outlines of control terminals and switches.
Illustration 1.3: Removing terminal cover.
The illustration below shows all control terminals of the frequency converter. Applying Start (term. 18) and an analog reference (term. 53 or 60) make the frequency
converter run.
Illustration 1.4: Overview of control terminals in PNP-configuration and factory setting.
AF-60 LP™ Micro Drive
DEH-41264A
7
1
To Next Page
Loading...
