GE AF-60 LP - Programming with Keypad

1.1.17 Programming with Keypad
For detailed information on programming, please see Programming Guide, AF-60 LP™ Micro Drive.
NB!
The frequency converter can also be programmed from a PC via RS485 com-port by installing the DCT-10 Drive Control Tool.
This software can be downloaded from the GE web site: www. geelectrical.com/drives
Illustration 1.6: Description of Keypad buttons and display
Use the [MENU] key to select one of the following menus:
Status:
For readouts only.
Quick Menu:
For access to Quick Menus 1 and 2, respectively.
Main Menu:
For access to all parameters.
Navigation Keys:
[Back]: For moving to the previous step or layer in the navigation structure.
Arrows [
▲
] [
▼
]: For manoeuvring between parameter groups, parameters and within parameters.
[OK]: For selecting a parameter and for accepting changes to parameter settings.
Operation Keys:
A yellow light above the operation keys indicates the active key.
[Hand]: Starts the motor and enables control of the frequency converter via the Keypad.
AF-60 LP™ Micro Drive
DEH-41264A 9
1