Equipment Overview
2001989-351A ApexPro™ 2-7
205A
ApexPro CH Transmitter
207B
CARESCAPE Telemetry T14 Transmitter
NOTE
In this manual, wherever the transmitter is shown, the ApexPro, ApexPro CH and
T14 transmitter are valid, except where otherwise noted.
Transmitter battery installation
NOTE
Refer to the ApexPro Telemetry System or the CARESCAPE Telemetry T14
Transmitter Operator’s Manual for further details on battery installation.
Install 2 new AA alkaline batteries in the transmitter.
1. Locate the battery cover at the bottom of the transmitter.
2. Slide the cover over to open the battery compartment.
3. Insert batteries, being careful to follow the polarity signs embossed on the lower
back side of the transmitter’s molded case.
To Next Page
Loading...
